Nitrile glove integrity multi point on port tester

Parameters:

III.Operation

1. Connect gas source to inlet of instrument , pressure is below 0.5Mpa.

2.  Setting test parameters in operation interface,include glove specification .

3. Put glove tray edge into glove port or sealing it ,notice to keep connection of between glove tray edge and glove port ,glove tray edge and glove flat ,then press start button, instrument will give edge of glove tray pressure,during this process, must sure put glove tray stability ,after sealing finished,start to give pressure to instrument until to set value,after that,instrument stop give pressure and start to test .

4. Test is over, there will show test result “Pass” or “Failed”

5. Press glove tray button, instrument exhaust pressure automatically,then get glove tray, test is over.

IV. Futures

1. The instrument take small amount of frequent and evenly air inlet, to avoid glove deformation

2. Color touch screen, friendly interface ,can test according to different test parameters, can choose and match best  proper program to test.

3. Portable easy to carry, fast connection.

4.History can print ,enquiry and storage.